Heavy Stainless Shutter Pintles |
Pintles are priced by the pair, enough to hang one shutter.
All hardware priced with e-coat finish, a very durable two part polymer process. Matching stainless steel fasteners provided with hardware – excludes masonry installation fasteners.
All pintles available as stock in 1”, 1-1/2”, 2” and 3” “standoffs”. Other standoff dimensions available to custom order.
It takes two pairs of our heavy pintles and to pairs of hinges to hang a normal pair of shutters on one window. |
|
SS302 Plate Pintle - A typical early pintle form, most commonly used through the 19th century. Works well on wood installations. Not recommended for masonry as the four fasteners are closely spaced.
Dimensions:
Plate 1-1/2” wide by 4-1/4” tall.
Pin 1/2” dia x 1 1/2” tall.
$ 44.00/pair
Dimensions:
Plate 1-1/2” wide by 4-3/4” tall.
Pin 1/2” dia x 2” tall.
$ 46.50/pair |
|
 |
SS303 Narrow Plate - One inch width lets this pintle fit on narrow mounting surfaces. Good choice for masonry with only two heavy mounting holes spaced well apart. Works well on board & batten. Requires wide bottom rail to fit above sills when installed on wood.
Dimensions:
Plate 1” wide by 4-1/4” tall.
Pin 1/2” dia x 1-1/2” tall.
$ 45.00/pair
Dimensions:
Plate 1” wide by 4-3/4” tall.
Pin 1/2” dia x 2” tall.
$ 47.50/pair |
|

|
SS304 – A Brandywine exclusive, specialty pintle moves pivot point to side of pintle, great for masonry. It is also a good choice when mounting to window casing – minimizes the required bottom rail width to accept the height of the pintle above the sill.
Dimensions:
Plate 3/4” wide by 4” tall.
Pin 1/2” dia by 1-1/2” tall.
$ 54.00/pair
Dimensions:
Plate 3/4” wide by 4-1/2” tall.
Pin 1/2” dia by 2” tall.
$ 56.50/pair |
|

|
SS305 Jamb Pintle - Mortises to the window frame, acts like door hinge.
We can provide this piece with two mounting holes if you are mounting into a masonry opening.
Dimensions:
Plate 3/4” wide by 4” tall.
Pin 1/4” dia by 1-1/2” tall.
$ 54.00/pair
Dimensions:
Plate 3/4” wide by 4-1/2” tall.
Pin 1/2” dia by 2” tall.
$ 56.50/pair |
|
|
SS306 Lag Screw Pintle - The screw shank is 1/2" dia. Strong, clean piece looks like drive when installed. The imports use a turned and welded fabrication. Their cheap approach looks tacky when compared to our heavy built lag pintles.
Dimensions:
Plate 3/4” wide by 4” tall.
Pin 1/2” dia by 1-1/2” tall.
$ 54.00/pair
Dimensions:
Plate 3/4” wide by 4-1/2” tall.
Pin 1/2” dia by 2” tall.
$ 56.50/pair |